The flared configuration is based on
flaring the pipe ends to 37 degrees and utilizing
flanges and internal cones. O-Ring face
o-ring seal mating to flat face cone.
Both internal cones have back-up o-rings
The flange is slipped onto the pipe before
flaring. After flaring, the cone is located
into the pipe. Bolting the flanges together
draws the flared pipes and cones in contact with each other providing a
Standard flare flanges and pipe are
available from 1/2" - 4" and pressures to
The standard connection styles offered
conform to SAE and ISO 4-bolt flanges.
Other flange patterns may also be